Xbox360FlashRemovalAndReplace

Stusy @ http://www.xboxhacker.net/forums/index.php?topic=1039.0

Stuff that I have about 17 years experience in the electronics repair trade and I use the method of freezing then heating the resin... after a few rounds of this the epoxy goes like silicon which can be esily picked out.

COLD

The freezer spray I use is:

 Ambersil Freezer

http://www.lawson-his.co.uk/scripts/details.php?cat=Fault%20Finding&product37793

HOT

Some Epoxy Removed

Chip Removed

New Chip Fitted
[1]

Switch - Looks good Damn Lucky the AV connector fits cause I didn't measure it

Fitted a SST39SF040 so I can have dual bios on 1 chip and just switch on pin1 (upper and lower addressing) mmmm seen this somewhere before lol

For the hitachi, you'd need to solder a switch between Pin 8 (Vdd (+5V)), and Pin 9 (A18) to switch between the two banks.

Retrieved from "http://www.eurasia.nu/wiki/index.php/Xbox360FlashRemovalAndReplace"

This page has been accessed 826 times. This page was last modified 18:57, 14 February 2010.